GiBiDi SNAPPER 250, Инструкция по установке

Страница: 19 / 48

18 19
SNAPPER SNAPPER
UK UK
The SNAPPER 250 operator for swing gates is an electromechanical device that transmits motion to the gate by
means of an articulated arm.
It is locked when the motor is not running, it is necessary to install locks
.
if fitted on
blind/flush panel doors
INTRODUCTION
WARNINGS FOR THE INSTALLER
• Before proceeding with installation, fit a magnetothermal and differential switch with a maximum capacity of 10A
upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening distance
of at least 3mm.
• All the packaging materials must be kept out of reach of children since they are potential sources of danger.
• The manufacturer declines all responsibility for proper functioning of the automated device if failing to use original
GIBIDI components and accessories suitable for the intended application.
• When installation has been completed, always carefully check proper functioning of the system and the devices
used.
• This instruction manual addresses persons qualified for installation of “live equipment”, therefore, good technical
knowledge is required exercised as profession in compliance with the regulations in force.
• Maintenance must be performed by qualified personnel.
• Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
• This product has been designed and constructed solely for the use indicated in this document.
• Any other use may cause damage to the product and be a source of danger.
• Verify the intended end use and take the necessary safety precautions.
• Use of the products for purposes different from the intended use has not been tested by the manufacturer and the
operations performed are therefore on full responsibility of the installer.
• Mark the automated device with visible warning plates.
• Warn the user that children and animals must not play or stand near the gate.
• Adequately protect the danger points, for example, using a sensitive frame.
• Check proper installation of the earthing system; connect all the metal parts of doors, gates, etc. and all the system
components equipped with earthing plate.
• Exclusively use original spare parts for any maintenance or repair.
• Do not make any modification to the components of the automated device unless expressly authorised by GIBIDI.
• Gi.Bi.Di. Srl reserves the right to change the technical data without prior notice in relation to product
development.
• In the event of an operating fault or failure, cut the power upstream of the control unit and call Technical Service.
• Periodically check functioning of the safety devices. Any repairs must be carried out by specialised personnel
using original and certified materials.
• The product may not be used by children or persons with reduced physical, sensorial or mental capacities, or
lacking experience and knowledge, unless appropriately instructed.
• Do not access the circuit board for adjustments and/or maintenance.
WARNINGS FOR THE USER
CAUTION: IMPORTANT SAFETY INSTRUCTIONS.
It is important to follow these instructions in order to safeguard persons.
Keep this instruction booklet