GiBiDi BL230, Инструкция по установке

Страница: 11 / 20

I I
10 11 BL230-BL233 BL230-BL233
Ammistratore Delegato
Oliviero Arosio
Dichiarazione di conformità CE
Il fabbricante:
GI.BI.DI.
Via Abetone Brennero, 177/B,
46025 Poggio Rusco (MN) ITALY
dichiara che i prodotti:
OPERATORI LINEARI ELETTROMECCANICI BL230
sono conformi alle seguenti Direttive CEE:
•
Direttiva EMC 2004/108/CE e successive modifiche
;
e che sono state applicate le seguenti norme armonizzate:
•
EN61000-6-1; EN61000-6-3
Data 04/07/2011
S.r.l.
UK
INTRODUCTION
INSTALLATION WARNINGS
The BL230-BL233 operator for swing gates is an electromechanical device that transmits motion to the gate by
means of a worm screw.
It is locked when the motor is not running, and it is therefore not necessary to install locks for leafs up to
2.5 m.
• Before proceeding with installation, fit a magnetothermal or differential switch with a maximum capacity of 10 A
upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening
distance of at least 3 mm.
• Keep all the materials contained in the packaging away from children, since they pose a potential risk.
• The manufacturer declines all responsibility for improper functioning of the automated device if the original
components and accessories suitable for the specific application are not used.
• After installation, always carefully check proper functioning of the system and the devices used.
• This instruction manual addresses professionals qualified to install “live equipment” and therefore requires
good technical knowledge and installation in compliance with the regulations in force.
• Maintenance must be carried out by qualified personnel.
• Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
• This product has been designed and constructed exclusively for the use indicated in this documentation.
Any other use may cause damage to the product and be a source of danger.
• Check the intended end use and take all the necessary safety precautions.
• Use of the product for purposes different from the intended use has not been tested by the manufacturer,
therefore any work is carried out on full responsibility of the installer.
• Mark the automated device with visible warning plates.
• Warn the user that children or animals should not play or stand near the gate.
• Appropriately protect the danger points, for example, using a sensitive frame.
• Check proper installation of the earthing system: connect all the metal parts of doors, gates, etc. and all the
system components to an earth terminal.
• Exclusively use original spare parts for any maintenance or repair operations.
• Do not modify any components of the automated device unless expressly authorised by Gi.Bi.Di..
• Use suitable cable clamps to ensure that the wiring is properly connected mechanically and such that an
IP44 degree of protection is maintained.