40
UK
41
UK
BA24
BA24
0 0 0
0
ESC
-
OK
+
The fourth digit blinks.
If you want to enter the ADVANCED programming, by means of
+ or – keys type the fourth digit of the installer code set in the menu E92.
Once you get to the desired digit confirm with the OK button and go to
the next step.
If you want to enter the BASIC programming, confirm the digit 0
The ESC button will move the flashing digit to the left until the first digit.
0 0 0 0
ESC
-
OK
+
By now the installer code is completed: if it is right you go to the next
step.
If the installer code is wrong the message P A S S appears again
A
C F H E
ESC
-
OK
+
Proceed with the programming of the menus following the instructions
in the relevant paragraphs.
Once the programming is completed press and hold for 3 s the ESC
button to store the settings and exit from programming procedure.
_ _ _ _ _
ESC
-
OK
+
If there is no mismatch between enabling and input status appears the
screen you can see here beside, otherwise it will appear an indication
of which input has a fault.
Refer to the paragraph “CHECK ENABLED INPUT”
In this case the b and OK will mean:
+
®
START
OK
STOP
®
0 0
0
0
ESC
-
OK
+
The third digit blinks.
If you want to enter the ADVANCED programming, by means of
+ or – keys type the third digit of the installer code set in the menu E92.
Once you get to the desired digit confirm with the OK button and go to
the next step.
If you want to enter the BASIC programming, confirm the digit 0
The ESC button will move the flashing digit to the left until the first digit.
A
C F H E
ESC
-
OK
+
When the display shows the main menus (letters A C F H E or just
some of them depending on which password has been used to access
programming) let the letter A blink by moving to the right or to the left
with the b or –
Once the letter A blinks confirm with the OK button
A 1 2
ESC
-
OK
+
By means of + or – buttons you can select the submenus (A1, A2, A3,…)
The digits on the lcd are fixed to show that is no possible any modification.
The button ESC lets you to go to the upper level (menus A, C, F, H E).
With OK button you enter the selected menu and the digits start blinking
to show that is now possible to modify the values and the ESC button
becomes irrelevant.
Right now with + and – buttons you can change the settings of the
selected menu.
With the OK button you confirm the data and return to the selected menu
with fixed digits.
MENU A: SYSTEM CONFIGURATION AND OPERATING LOGIC SELECTION
A 2 3
ESC
-
OK
+
Right now with + and – buttons you can scroll the other submenus of
the menu A and you can follow the same procedure shown above.
The ESC button lets you to go to the upper level (menus A, C, F, H E).
Menu
Function
Status Description
A1
A2
TYPE OF INSTALLATION
NUMBER OF MOTORS
2
3
2
3
It configures the system for swing gate, overhead door or barrier
It configures the system for a sliding gate
This configuration automatically excludes:
• gate phase shifts in opening and closing
• hammer stroke
• 2 seconds final opening and closing stroke
• T3 time
• hydraulic locking maintenance
WARNING
The limit switches are NOT activated automatically, choose the best
configuration with the menu C4
It configures the system for one motor.
With this setting, the outputs for the electrical lock 2 can be used for
a 3 minutes timed courtesy light.
It configures the system for two motors.
Example Programming
MENU A
Description
MENU A
Содержание BA24
Страница 59: ...59 NOTE NOTES BA24 ...
