Ghibli FR30 TOUCH, Использование и обслуживание

Страница: 36 / 602

EN
EN-8
50) Aspirator start button “ ”
Button operation is enabled by pressing
the button (45) “ ”.
Press the button (50) “ ”, the aspirator
will start to function; the symbol “ ” ap-
pears on the display.
To turn off the aspirator, press the button
(50), the turbine will continue to function
for a few seconds in order to aspirate the
liquid on the floor, afterwards it will turn
off automatically. The symbol “ ” will
disappear from the display
49) Silent operation button “ ”
Pressing the button (49) “ ” reduces
the speed of the intake turbine, which
considerably reduces the machine noise
; the symbol “ ” appears on the display
with the function enabled.
Pressing again button (49) “ ” turns off
the function and the machine will start to
operate again in standard mode; symbol
“ ” appears on the display.
NOTE:
When turning off the aspiration turbine with
“silent operation” mode enabled, the opera-
tion of the turbine will automatically switch
to “standard operation” mode for the entire
shut-off delay time.
51) Water solenoid valve button “ ”
Button operation is enabled by pressing
the button (45) “ ” and button (52) “
”.
Press the button (51) “ ”, the display
will show the symbol “ ”, and the open-
ing of the water solenoid is being pre-
pared. Its operation is controlled by the
sensor (20).
The water quantity can be adjusted using
the tap (4).
To stop water dispensing, press the but-
ton (51) “ ”.
52) Brush rotation enable button “ ”
Button operation is enabled by pressing
the button (45) “ ”.
Press the button (52) “ ”, and the
brush rotation will be activated; the dis-
play will show the symbol “ ”. Brush/es
operation is controlled by the sensor (20).
To stop brush rotation, press the button
(52) “ ”.
4) Water quantity adjustment tap
- Turn the tap (4) counter-clockwise to
increase the quantity of water or turn it
clockwise to decrease it.
6.2 WORKING CYCLE EX-
AMPLE
(Fig. 9)
Setting a washing cycle with brushes and
drying.
- Press the button (51) to allow the water
supply.
- Press the button (52) to allow brush rota-
tion.
- Press the button (50) and the vacuum will
start.
NOTE:
In special environments it is possible to acti-
vate the noise reduction function by pressing
the button (49).
WARNING:
At startup be careful not to touch the
touch sensor (20); the machine will go to
alarm mode.
If you release the sensor within two sec-
onds, the alarm will automatically turn off
and after more than two seconds you will
need to stop and restart the machine.
FR30 TOUCH_27lingue_1ed_05-2014.indd 8 27/06/14 16:55