gfm PeakStore5, Руководство пользователя

Страница: 34 / 37

32 PeakStore5 Manual Version 3.0
•
Cutting of speed and sensor signals
•
Adaption of envelope and FFT parameter
•
Renaming of sensor names to measurement positions
The calculated measurement data are finally inserted under the measured machine in the de-
vice browser of the Peakanalyzer Manager. The analysis of the calculated data can then be
done with the usual analysis tools of the Peakanalyzer Manager. Detailed information about
the Diagnostic Tool and the analysis tools can be found in the manual of the Peakanalyzer
Manager.
7.
Remote Control
There is a free of charge App for the Smartphone platforms Android from version 4.1 and iOS
from version 9.2 available that allows the remote control of the PeakStore5. The PeakStore
Remote App must be installed from the corresponding store. An active WLAN connection must
be established between Smartphone and PeakStore5 to get the PeakStore Remote App work-
ing. It is recommended to use an additional WLAN route as access point between these two
where both devices are connected to. A battery driven WLAN router can also be ordered as
additional component at GfM Gesellschaft für Maschinendiagnose mbH.
Picture 31: Connect PeakStore Remote App to PeakStore5
If the WLAN connection is established on both sides, the PeakStore Remote App can be
started and a broadcast search for the PeakStore5 can be done. If the PeakStore5 is not au-
tomatically found, the PeakStore5 can be added manually. Therefore the IP address of the
WLAN connection of the tablet, that is shown in the sensor overview if configured, must be
entered in the App.
If the connection to the PeakStore5 is established successfully, the overview page will open.
The PeakStore5 must be in the measurement overview. If the configuration view or data man-
agement is opened, a measurement cannot be started.