USER INSTRUCTIONS
E
N
G
L
I
S
H
13
Parameter setting
To set the operating parameters of the thermostat, humidity, and any remote elements
(e.g. KNX temperature adjustment probes), press the
button key.
To quit the parameter setting procedure without saving the modifications made on the
current page, just press the
button key again or wait 30 seconds from the last pressure
on the button keys. The parameters that can be modified will depend on the page you
are viewing in normal operation status: if the visible page relates to the thermostat, the
Set menu concerning the thermostat will be shown; if the visible page is that of a general
remote element, the Set menu concerning the selected element will be shown; if the
visible page relates to the humidity section, the Set menu concerning the selected
humidity threshold will be shown.
The parameters relating to the thermostat and humidity are collected into three functional
groups: general parameters, operating parameters, and control parameters. Each group
can be enabled or disabled for visualisation and/or local modification, by setting the ETS
parameter “Local parameter modification” of the “General” menu.
General parameters
Setting the hour
When the hour figures are flashing, set the hour using the
button keys.
To confirm the set value and move on to the next parameter,
press the
button key within 30 seconds.
Setting the minutes
When the minute figures are flashing, set the minutes using
the
button keys.
To confirm the set value and move on to the next parameter,
press the
button key within 30 seconds.
Setting GMT / daylight-saving time
Use the
or
button key to choose either GMT or
daylight-saving time (OFF = GMT; ON = daylight-saving
time). This screen is only visible if the parameter has been
enabled from ETS. To confirm your choice and move on to
the next parameter, press the
button key within 30
seconds.
