P.7
4. 先按溫度按鍵，再按電源開關：關閉電源。
Press the temperature button first, then press the power switch: shut off the power source.
5. 先按一個溫度按鍵，再按另外一個溫度按鍵：水將會加熱至第二次選擇的溫度，並且以該溫度
保溫。
Press one temperature button first, then press the other temperature button: the water will be
heated to the second selected temperature and keep warm on there.
6. 先按電源開關，然後按其中一個溫度按鍵，再按另一個溫度按鍵：水壺將煲水，然後直接以第
二次選擇的溫度保溫。
Press the power switch first, and press one temperature button, then press another temperature
button: the kettle will boil the water, and reduce to the second selected temperature directly and
keep warm at that temperature.
操作說明
Operating Instructions
在使用水壺之前
Before Using Your Kettle
水壺的操作
Operating Your Kettle
初次使用水壺時，建議在使用前先煲滿一壺水兩次，然後將水倒掉，然後濕布清潔水壺表面。
If you are using the kettle for the first time, it is recommended that you should clean your kettle before
use by boiling a full kettle of water twice and then discarding the water. Wipe the surface with a damp
cloth.
注意：水壺的最大容量為1.5公升。
NOTE: The maximum capacity of kettle is 1.5L.
1. 裝水時，將壺身抽出電源底座，然後按開蓋按鈕打開水壺蓋，裝入所需水量，然後關上蓋
子。水壺也可通過壺嘴裝水。水量不能超過「MAX」標準線，或者低於「MIN」標準線。水
量過少會導致水在煲滾前停止煲水。
To fill the kettle, remove it from the power base and open the lid by pressing the Lid Release
Button, fill with the desired amount of water, and then close the lid. Alternatively, the kettle may
be filled through the spout. The water level should not exceed MAX marks or sit below MIN level.
Too little water will result in the kettle switching off before the water has boiled.
注意：注水時請勿超過最大水量標準線，因為當水沸騰時，水會從壺嘴溢出。在插上插座前
請確保水壺蓋牢固蓋好。
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place before plugging the power outlet.
