GEOSATpro DVR 1000ci, Руководство пользователя

Страница: 9 / 30

14
Operations
Operations Operations
15
Operations
͋
Select the satellite you want with or .
͌
Press to move to TP section and select the TP you want with or .
͍
When the satellite and the TP are selected, you can check the reception status of the
satellite signal. If the reception signal status is bad, adjust antenna to get the following
result.
VOL VOL
CH
VOL VOL
4. Antenna Setup
You need to position your antenna correctly for reception of the best signal.
͈
Press MENU key.
͉
Select ‘Installation’ with or , and press .
͊
Select ‘Antenna Setup’ with or and press .
CH
CH
CH
CH
Level Indicating selected satellite signal strength level
Quality Indicating signal to noise ratio
Tuner LOCK FEC 1/2, 2/3, 3/4, 5/6, or 7/8
Level over 30% Quality over 10%
͎
DiSEqC 1.2 Positioner Setting
- Motor / Goto 0
Determine the kind of Motor & whether or not controlling it by using or .
VOL VOL
If you press , DiSEqc Motor will move toward Zero Equator.
- Move / Save
Motor moves to West & East direction.
- Set Limit
Determine the value of Limit of Motor.
If you select
, the value of Limit will be changed.
- My longitude / My latitude
You can use this item when USALS is selected ‘Motor/Goto 0'.
Determine you site longitude and latitude
‘East/West' is changed by using or .
VOL VOL
DiSEqC 1.2 Using DiSEqC 1.2 compatible motor
OFF Not using DiSEqC Motor.
USALS
Using USALS compatible Horizon motor. input the install location
longitude and latitude. the receiver will drive the satellite dish to the
position calculated from the site location.
5. Satellite Scan
After finishing ‘Antenna Setup’, execute a ‘Satellite Scan’.
Then you can get all channels in the pre-programmed TPs. This function can also be
used to get the latest channel data while receiver is in use. Through this function, the
receiver searches for all the available channels and saves them in the memory.
͈
Press MENU key.
͉
Select ‘Installation’ with or , and press .
͊
Select ‘Satellite Scan’ with or , and press .
͋
Select ‘Scan Mode’ with or .
͌
Select the scan mode you want with or .
VOL VOL
CH
CH
CH
CH
CH
CH
6.1 6.1