Geo BJ 120, Руководство по эксплуатации и обслуживанию, Страница: 15 / 39

15
12
ASSEMBLY
General information:
Read and ensure you understand the full
assembly instructions before you begin
assembling your machine.
The machine is delivered ex works in
transport configuration. Always use tools,
appliances, and lifting equipment of
suitable size and power for installation.
Always use 2 people to lift, move and
assemble the machine. Wear suitable
protective clothing such as safety shoes,
safety goggles and protective gloves.
Observe the safety precautions as
described in chapter
"Safety" of these
operating instructions. Verify all screws and
nuts are fitted correctly when assembling
the machine. When opening the wooden
crate, beware of sharp edges on the locking
mechanisms.
Please note when beginning machine
assembly:
-
Clear the area of nearby persons,
particularly children.
-
Use suitable lifting equipment to
move or raise the pallet/machine.
-
Keep the load close to the ground.
-
Move the device to the assembly site.
-
Ensure there is enough room to
safely assemble the device and
access it from all sides.
Other important information:
Connecting the electromagnetic control
valve (switches over between sickle bar
blade drive and vertical sickle bar
adjustment)
requires a 12 V connection on
your machine.
You will further need lugs to make the
connection and a cable extension for the
specific 12V socket on your machine. A
changeover switch (e.g. pressure or toggle
switch) is also required to be able to operate
the electromagnetic control valve correctly.
This is not included with the machine, since
the connections on the machine are too
specific and cannot be mass produced.
Various machines may already be factory
equipped with this function. The switch itself
must have the following functions: The
sickle bar adjustment (horizontal and
vertical direction) must respond when
pushing the switch, meaning the hydraulic
cylinder is being actuated. After releasing
the switch the electromagnetic control valve
then redirects the hydraulic oil flow back to
the hydraulic motor to power the blades.
Verify all hydraulic connections and
screw connections are seated correctly
and tight during installation and prior to first
use, and regularly before use. Once
installed, verify the hydraulic hoses are
connected properly and tighten as
necessary. When doing so, please
remember the THS-180 also has a
mechanical lateral adjustment and ensure
the hydraulic hoses are able to work
properly when fully extended, they must not
be crushed.
The control block for the electromagnetic
valve typically comes with the flow regulator
connected. If once the machine is fully
assembled you notice during the first test
run the switch doesn’t work as described in
the sections above, reverse