Geo Knight Maxi Press Air, Руководство пользователя

Страница: 8 / 13

Once the Left and Right rail sections have been attached, the next step is to attach the
LEFT AND RIGHT stop end tubes. These 1” x 3” black aluminum tubes attach to the very end
of each side rail section. The hardware needed should already be screwed into the tapped holes
for attachment.
LEFT SIDE RAIL SECTION SHOWING THE END TUBE AND CROSS CHANNELS
With both the Left and Right rail sections attached and level, position the loading table
that was shipped separately from the press. This is done by rolling the loading table into the rail
section from the proper end. This is determined by the loading table that was already on the press
when shipped.
•
Remove the end stop tube from the side that the loading table must be rolled in from.
•
Lift the loading table using a fork lift to the height needed to feed and roll the loading table
onto the rail assembly.
•
Carefully roll the loading table onto the aluminum rails. Lift the opposite side it is entering
from to prevent the handle brackets from making contact with the rail.
•
Once the entire loading table is in place, re-attach the end stop tubes.
•
Proceed with attaching the handle to the front of the loading table using hardware supplied.
With both loading tables on the rail sections and the end stop tubes in place, roll each
table carefully back and forth to test the motion. If it is difficult to manually move the loading
table, adjust the lower neoprene roller bracket on the loading tables to reduce the amount of
friction against the rails.
In order for the MAXI PRESS to activate, there is a safety lever switch that must be
depressed with the loading table under the heater block. In the event that the machine does not
activate properly, inspect this lever switch and hardware to adjust for proper operation.
LEFT SIDE
STOP END
TUBE
LOWER LEG
CROSS CHANNELS