Gentex TBH IIIA Series, Руководство оператора

Страница: 21 / 40

17
MAINTENANCE
REPLACING SUSPENSION (PAD/LINER) — ADJUSTABLE
REMOVE THE EXISTING PADS.
Remove the pads from the helmet, noting their position and orientation in the helmet.
Look inside each of the removed pads, noting which foam pads are installed inside the cover.
INSTALL THE REPLACEMENT PADS.
If only the ½-inch-thick foam pads were used in the previous pads, remove the ¼-inch-thick foam
pads from the replacement pads. Otherwise, leave the ¼-inch-thick foam pads inside.
Install the replacement pads in the helmet in the same manner in which the previous pads were
installed. If the wearer uses a headset, space the crown pads to accommodate the headband of
the headset.
Don the helmet, and check the fit in accordance with
Page 9 and Page 12. Make any
necessary adjustments.
Each pad contains one ½-inch-thick foam pad and two ¼-inch-thick foam pads inside the cover.
For impact protection and helmet stability, you must keep all ½ -inch-thick foam pads inside
the covers and all pads properly installed in the helmet when the helmet is worn. Remove the
¼-inch-thick pads only where necessary to adjust the fit.
1
2
Crown
Crown
Bottom
Bottom
Bottom
Bottom
Bottom
Bottom
¼ inch thick
foam pads
Pad cover
Opening
½ inch thick
foam pad
PAD DETAIL