Gentex TBH IIIA Series, Руководство оператора

Страница: 15 / 40

11
HELMET PREPARATION
CHECKING SUSPENSION (PAD/LINER) FIT — 360
°
LINER
PLACE THE HELMET ON THE HEAD.
Leave the chin strap loose for now. Allow the helmet to settle on the head for a few minutes before
checking the fit. Ensure that the front pad is just above the eyebrows. If necessary, adjust the fit
as follows:
• Helmet too high or
too tight:
Remove the
½-inch-thick comfort pads
and install the ¼-inch-
thick pads as shown.
Re-check the fit.
• Helmet too low or too
loose:
Remove the
½-inch-thick comfort pads
and install the ¾-inch-
thick pads as shown.
Re-check the fit.
NOTE:
The 360
°
Liner kit is shipped with the ½-inch-thick comfort pads installed. The ¼-inch thick
comfort pads and the ¾-inch-thick comfort pads are included in the package. You can use a combination
of pad thicknesses to achieve the best comfort and fit.
IF USING A HEADSET, CONFIGURE THE PADS ACCORDINGLY.
Remove the comfort pad
located at the crown.
PROCEED TO ADJUSTING RETENTION (CHIN STRAP) — PAGE 12.
Ensure the helmet is properly adjusted for a snug, secure fit at all times when the helmet
is worn. Failure to do so can result in an unstable helmet that will not protect the wearer.
1
3
2
¼ inch thick
comfort pads
½ inch thick
comfort pads
¾ inch thick
comfort pads
Pad removed