Gentex TBH IIIA Series, Руководство оператора

Страница: 12 / 40

8
HELMET PREPARATION
CHECKING SUSPENSION (PAD/LINER) FIT — TEAM WENDY
PLACE THE HELMET ON THE HEAD.
Leave the chin strap loose for now. Allow the helmet to settle on the head for a few minutes. Ensure
that the front pads are just above the eyebrows. If necessary, adjust the fit as follows:
•
Helmet too high or too tight:
Remove the pads and install a thinner pad set (ordered separately)
as shown. Re-check the fit.
•
Helmet too low or too loose:
Remove the pads and install a thicker pad set (ordered separately)
as shown. Re-check the fit.
NOTE:
The Team Wendy pad kit is available in the following thicknesses: ¾-inch-thick pads, and
1-inch-thick pads (with a ¾-inch-thick crown pad). The helmet is supplied with one of these pad sets.
The user must order other pad sets separately if needed.
PROCEED TO ADJUSTING RETENTION (CHIN STRAP) — PAGE 12.
1
Ensure the helmet is properly adjusted for a snug, secure fit at all times when the helmet
is worn. Failure to do so can result in an unstable helmet that will not protect the wearer.
2
TEAM WENDY PADS
Crown
Front/Rear
Lateral
Lateral
Lateral
Lateral
Front/Rear