Genie GTH-6622, Руководство оператора

Страница: 57 / 124

Document 57.0005.8200 - 12/2005
Handler with telescopic boom GTH-6622
Page
C-23
OPERATING INSTRUCTIONS
■
C-4.7 STOPPING AND PARKING THE
MACHINE
When possible, stop the machine on a dry, level and
solid ground. Then:
• Bring the machine to a smooth stop by easing up
the gas pedal and stepping down on the brake
pedal.
• Set the forward/back speed lever to neutral
position.
• Engage the parking brake pressing button 18 (the
warning light on the pushbutton must be on).
• Release the service brake pedal.
• Rest the attachment coupled to the boom flat on
the ground.
• Rotate the ignition key to “ 0 ” and remove the key.
• Leave the driving cab and lock the cab door.
• Disconnect the battery (see chapter C-4.5).
DANGER
Always face the machine when getting off the
driving cab; make sure that your hands and shoe
soles are clean and dry, and hold to the handholds
to prevent falls or slips.
DANGER
Always engage the parking brake after stopping
the machine to prevent possible accidental motions
of the vehicle.
C-5 USING THE HANDLER
This chapter describes some techniques and provides
instructions for a safe use of the machine fitted with
standard forks. Before using different attachments,
thoroughly read the chapter “Optional attachments".
CAUTION
Before using the machine, inspect the job site and
check for possible hazardous conditions. Make sure
that there are no holes, moving banks or debris that
may cause you to lose the control of the machine.
ELECTRICAL
DANGER
Pay the greatest attention when working close to
electric lines. Check their position and ensure that
no part of the machine operates at less than 6
meters from the power lines.
CAUTION
For a safe use of the machine, always check the
weight of the loads going to be handled.
Always refer to the load charts applied on the cab
windscreen or to the quick guide with the fork
capacity ratings.