Genie GTH-6622, Руководство оператора

Страница: 56 / 124

Document 57.0005.8200 - 12/2005
Handler with telescopic boom GTH-6622
Page
C-22
OPERATING INSTRUCTIONS
■
C-4.4 LOW TEMPERATURE STARTING
In case of cold starting, use an oil with a SAE viscosity
adequate to the ambient temperature.
Please refer to the DEUTZ engine use and maintenance
manual.
The machine is supplied with oil SAE 15W/40.
To start the engine from cold, proceed as follows:
• Put the forward/reverse speed selection lever to
neutral.
• Turn the ignition switch to position and wait
until the warning light 6 signalling the glow plugs
preheating goes off. Step down on the gas pedal
and start the engine turning the ignition switch to
. Release as soon as the engine starts.
• Let the engine run at idle for a few seconds before
putting a gear; this allows for a gradual warm up of
the engine oil and a better lubrication.
• In case of engine jump-starting, remove the booster
ables (see chapter C-4.3).
■
C-4.5 DISCONNECTING THE BATTERY
Before any maintenance or repair work, and especially
before welding any components on the machine,
remove the cables at the battery.
CAUTION
Before disconnecting the battery, set all switches
within the cab to OFF.
To disconnect the battery, disconnect the negative
(-) lead from the frame earth first. To connect the
battery, connect the positive (+) lead first.
■
C-4.6 STARTING THE MACHINE
When the engine reaches the running temperature,
ensure all parts are in transfer position and the gearbox
lever is in neutral. Then, proceed as follows:
• Select the required steering mode.
• Select the required gear (forward or reverse).
• Release the parking brake pressing button 21 (the
warning light on the pushbutton must be off).
• Slowly step on the gas pedal to start moving off.
CAUTION
Do not operate the forward/reverse gear lever when
the machine is running. The machine would reverse
the running direction abruptly and you could
seriously be injured.