4
Features
2
SAFETY FEATURES
Safe-T-Beam
®
(STB) Non-Contact
Reversing System
Puts an invisible beam across the door opening.
The door stops and reverses to the full open
position if anything passes through the beam.
LED indicator lights on the powerhead and on
the STBs provide a self-diagnostic code if an
operational problem exists.
Safe-T-Reverse
®
Contact Reversing System
Automatically stops and reverses a closing door
within two seconds of contact with an object.
Automatic ForceGuard
™
Control
Automatically sets the force required to fully
open and close the door for maximum safety.
Watch Dog
™
Monitoring System
Monitors the Safe-T-Beam
®
system to ensure
proper functionality and will automatically stop
and reverse a closing door if a problem
is detected.
Manual Emergency Release
Manually releases door from door opener. Used
during a power failure or other emergency to
allow manual opening and closing of door.
SmartSet™ Electronic Programming
Easily adjust the programming to reduce
opening speed to a desired rate, vary limits
and force, and program new remotes.
Automatic Lighting System
Two bulb lighting system supplies light for safer
evening exits and entries. Turns
ON
when door is
activated and automatically turns
OFF
4 minutes
later.
Integrated Motion Detection
(
Not available on
all models
)
Some units have motion detection built into the
powerhead. Lights automatically turn
ON
when
motion is detected for much safer movement
through the garage. Lights will turn
OFF
after
4 minutes of no motion.
OPENER FEATURES
INTELLICODE
®
2 Access Security System
A new generation superior encryption system
that enhances the security of the door opener
by continuously changing the access code each
time the remote is used. The door opener re-
sponds to each new code only once. An access
code copied from a working system and tried
again, will not control the door opener.
Wall Console
Operates door opener from inside garage.
The wall console has an indicator light with:
Open/Close, Sure-Lock
™
, and independent
light control buttons.
Home Link and Car2U
®
compatible. Refer to the
programming instructions on page 11.
NOTE:
Use this manual
ONLY
after completing assembly
and installation of opener. Review
Assembly/Installation
Instructions
poster. Check that all steps have been
completed.
Contact your Genie® Professional Dealer for an
Assembly/Installation Instructions
poster, if needed,
or call 1-800-35GENIE. You can also go to
www.geniecompany.com
to download a printable file.
Begin here ONLY AFTER completing assembly and installation of the opener. Review the
Assembly and Installation
poster to ensure all steps have
been performed.
There are no assembly or installation steps included in this manual. Contact your Genie® Professional Dealer for an installation poster, if needed,
or call 1-800-35GENIE. You may also visit www.geniecompany.com to download a PDF file.
INFRARED PROTECTION FUNCTION
1. The Safe-T-Beam
®
has no effect on the door during an opening cycle.
2. If the Safe-T-Beam
®
detects an obstruction when trying to close the
door, it will not allow the door to close.
3. When the garage door is closing, if Safe-T-Beam
®
is interrupted by
a person or obstacle, the garage door will stop its downward travel
and reverse automatically to its fully opened position.
4. If the Safe-T-Beam
®
System fails, loses power, or is installed
improperly, press and hold the wall console “open/close” button
until the door reaches its fully closed position. If you release the
“open/close” button on the wall console during the
closing
movement, the door will reverse automatically to its fully-opened
position.
