SY-SIX-CTRL-DIN-1D | Synergis IX DIN Rail Single Door Controller | Installation Manual
Last Updated August 2018
8
Mounting
The Controller is designed to mount on standard DIN Rail either in dedicated DIN cabinets or generic DIN Rail
mounting strip.
When installing the Controller ensure that there is adequate clearance around all sides of the device and that
air flow to the vents of the unit is not restricted. It is recommended to install the Controller in a location that will
facilitate easy access for wiring. It is also recommended that the Controller is installed in electrical rooms,
communication equipment rooms, closets or in an accessible area of the ceiling.
1. Hook the lower tabs under the bottom edge of the DIN Rail.
2. Push the Controller against the DIN Rail mount until the upper tab clips over the upper rail.
Removal
The Controller can be removed from the DIN Rail mount using the following steps:
1. Insert a flat blade screwdriver into the hole in the tab at the top of the Controller.
2. Lever the tab up and rotate the unit off the DIN Rail mount.
