Genesis COUPE BK 2010, Руководство пользователя

Страница: 16 / 168

After a repair, it is essential to verify that the fault has been corrected.
ُ Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was
repaired and PCM/TCM memory was not cleared. Throughly check connectors for looseness, poor
connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as
necessary and go to "verification of vehicle repair" procedure.
ُ Go to "W/Harness Inspection" procedure.
Terminal & Connector Inspection
1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by
interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
ُ Repair as necessary and go to "verification of vehicle repair" procedure.
ُ Go to "Power circuit inspection" procedure.
Power Circuit Inspection
1. Connect the "PCM/TCM" connector.
2. IG "ON" & Engine "OFF".
3. Measure the voltage between "Solenoid Supply" terminal of solenoid valve connector and chassis ground.
Specification : Battery Voltage
4. Is the measured voltage within specifications?
ُ Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was
repaired and PCM/TCM memory was not cleared. Throughly check connectors for looseness, poor
connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as
necessary and go to "verification of vehicle repair" procedure.
ُ Check open or short in harness. Repair as necessary and then, go to "Verification of Vehicle"
procedure.
ُ If there is no problem in harness, substitute with know-good PCM/TCM and check for proper
operation. If the problem is corrected, replace PCM/TCM as necessary and then go to "Verification of
Vehicle Repair" procedure.
Verification of Vehicle Repair
1. Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.
2. Using a GDS, Clear DTC.
3. Operate the vehicle within DTC Enable conditions in General information.
4. Are any DTCs present ?
ُ Go to the applicable troubleshooting procedure.
ُ System performing to specification at this time.