Genesis COUPE BK 2010, Руководство пользователя

Страница: 21 / 168

After a repair, it is essential to verify that the fault has been corrected.
SW
3 ON
N range
SW
0.11V 5.17V 4.16V 5.08V
4 ON
D range
SW
0.11V 0.11V 4.17V 0.11V
4. Is the measured voltage within specifications?
ُ Go to "Component inspection" procedure.
ُ Check for open or short in harness. Repair as necessary and Go to "verification of vehicle repair"
procedure.
ُ If signal circuit in harness is OK, Substitute with a known-good PCM/TCM and check for proper
operation. If the problem is corrected, replace PCM/TCM as necessary and go to "verification of
vehicle repair" procedure.
Component Inspection
1. IG "OFF" & Engine "OFF".
2. Disconnect ATM control Unit(CHG75-1 & CHG75-3) connector.
3. Measure resistance between signal and ground terminal of range switch connector (Component Side)
Normal Condition(Any other conditions are treated as failure)
Ɣ ᧶ SWITCH IS ON(GND LEVER)
᧩᧶
RANGE INDICATER LAMP "OFF" AND MAINTAIN PREVIOUS RANGE
Specification : Refer to below table
PIN No
(CHG75-
3)
GND
TransmissionRange
Switch1(S1)
TransmissionRange
Switch1(S2)
TransmissionRange
Switch1(S3)
TransmissionRange
Switch1(S4)
IND
P-R
(Middle)
Ɣ Ɣ
-
R
Ɣ Ɣ Ɣ Ɣ
R
N-R
(Middle)
Ɣ Ɣ Ɣ Ɣ
-
N-D
(Middle)
Ɣ Ɣ Ɣ Ɣ
-
D
Ɣ Ɣ Ɣ Ɣ
R
4. Is the measured resistance within specifications ?
ُ
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination,
deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle
Repair" procedure.
ُ Check for open or short in harness. Repair as necessary and Go to "verification of vehicle repair"
procedure.
ُ If signal circuit in harness is OK, Substitute with a known-good "TRANSMISSION RANGE SWITCH"
and check for proper operation. If the problem is corrected, replace "TRANSMISSION RANGE
SWITCH" as necessary and go to "verification of vehicle repair" procedure.
Verification of Vehicle Repair
1. Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.