General 90-050, Руководство по установке и эксплуатации, Страница: 3 / 24

1. Learn the machine’s applications and limitations, as
well as the specific potential hazards particular to this
machine. Follow available safety instructions and
safety rules carefully.
2. Keep working area clean and be sure adequate light-
ing is available.
3. Do not wear loose clothing, gloves, bracelets, neck-
laces, or jewellery while operating the bandsaw. Wear
face, eye, ear, respiratory and body protection
devices, as indicated for the operation or environ-
ment.
4. Keep hands well away from blades and all moving
parts.
Do not clear chips and sawdust away with
hands. Use a brush.
5. Make sure all cutting tools are moving at operation
speed before feeding.
6. Do not feed the material too quickly. The cutting tool
will perform better and be safer working at the rate for
which it was designed.
7. Whenever possible use a dust collector with shaving
hood to minimize health hazards.
8. Never leave the machine with the power on.
9. Stop the feeder before stopping the cutting tool.
10. Keep children away. Make sure that visitors are kept
at a safe distance from the work area.
11. Never stand on tool. Serious injury could occur if the
tool is tipped or if the cutting tool is unintentionally
contacted.
12. Adjust blade tension and tracking before starting to
cut.
13. Use suitable support if stock does not have a flat sur-
face.
14. Do not force the machine. It will do the job better and
be safer at a rate for which it was designed.
15. Keep guards in place and in working order. If a guard
must be removed for maintenance or cleaning make
sure it is properly attached before using the tool
again.
16. Be sure that key and adjusting wrenches have been
removed before turning power on.
17. Use only accessories designed for the machine.
18. Do not work on long stock without adequate support
on the out feed end of the table.
19. Make sure tool is properly grounded. If tool is
equipped with three-prong plug, it should be
plugged into a three-pole electrical receptacle. Never
remove the third prong.
20. Always disconnect tool before servicing and when
changing accessories such as blades, bits, cutters.
21. Make sure that switch is in "OFF" position before plug-
ging in cord.
22. Adjust and position upper and lower blade guides
before starting to cut. Upper blade guide should be
adjusted to approximately 1/8” above the material to
be cut.
23. Hold material firmly against the table.
24. Saw teeth must point down toward the table.
25. Use ONLY recommended accessories. Use of acces-
sories NOT recommended by General International
may result in a risk of injury.
26. Do not use this bandsaw for other than it’s intended
use. If used for other purposes, General International
disclaims any real or implied warranty and holds itself
harmless for any injury, which may result from that use.
Rules for Safe Operation
To help ensure safe operation, please take a moment to learn the machine’s applications and limita-
tions, as well as potential hazards. GENERAL® INTERNATIONAL disclaims any real or implied war-
ranty and holds itself harmless for any injury that may result from improper use of its equipment.