General 90-050, Руководство по установке и эксплуатации, Страница: 10 / 24

RECOMMENDED ADJUSTMENTS
Before making any adjustments, make sure that the switch is in the “OFF” position and that the power cord is
unplugged.
TILTING THE TABLE
1. Loosen both table lock knobs underneath the table.
2. Manually tilt the table to the desired angle on the
scale under the table.
3. Tighten the knobs to secure the table at the desired
angle.
ADJUSTING THE 90
°
TABLE STOP
1. Loosen both table lock knobs underneath the table
and tilt the table to the right.
2. Loosen the nut on the table stop bolt and lower
the stop bolt as far as possible.
3. Place a combination square on the table against
the saw blade.
4. Adjust the tilt of the table left or right until it is 90° to the
blade. Make sure there is no space between the square
and the blade. Tighten the lock knobs
.
5. Adjust the table stop bolt up until it touches the
underside of the table.
6. Loosen the lock knobs and verify that the table is rest-
ing on the stop bolt .
7 . Check the square to make sure the table is still
90° to the blade. If not, re-adjust the stop bolt as
needed.
8 . When the adjustment is accurate at 90°, tighten down
the nut on the stop bolt , tighten the table lock knobs
and align the pointer to the 0° mark on the angle
indicator scale
.
10
Make sure the blade is in the center of the table insert slot before operating.
To install a blade, repeat the previous steps (Pg. 9) in
reverse order, making sure that the blade is installed with
the teeth pointing forward and down as shown.
With the blade installed, re-attach the extension table and
then proceed to “BLADE TENSION ADJUSTMENTS” and
“BLADE TRACKING ADJUSTMENTS” in the “RECOMMENDED
ADJUSTMENTS” section of this manual, Pg. 11.
Proper installation
Improper installation