Generac Portable Products 1330-0, Руководство пользователя

Страница: 15 / 24

15
Generac Portable Products 2000PSI High Pressure Washer
• Remove additional debris by back flushing water
supply through wand extension (Figure 17). Back
flush between 30 to 60 seconds. Turn wand
extension to stream spray and move nozzle from
low to high while flushing.
• Reinstall nozzle into the wand extension. DO NOT
over tighten.
• Reconnect the wand extension to the gun.
• Reconnect the water supply, turn on the water, and
start the engine.
• Test the pressure washer by operating with nozzle
in the high and in the low position.
O–Ring Maintenance
Through the normal operation of your pressure
washer, o–rings, which keep the connections of the
hoses and gun tight and leak–free, may become worn
or damaged.
Provided with your pressure washer is an O–Ring
Maintenance Kit (p/n B3057) which provides
replacement o-rings, rubber washer and water inlet
filter.
To remove a worn or damaged o–ring:
• Use a small flathead screwdriver to get underneath
the o-ring and pry it off.
ENGINE MAINTENANCE
See the Engine Owner’s Manual for instructions on
how to properly maintain the engine.
PREPARING UNIT FOR
STORAGE
Water should not remain in the unit for long periods of
time. Sediments of minerals can deposit on pump
parts and “freeze” pump action. If you do not plan to
use the pressure washer for more than 30 days,
follow this procedure:
1. Flush chemical injection tube by placing the filter
into a pail of clean water while running pressure
washer in low pressure (adjustable nozzle in
forward position). Flush for one to two minutes.
2. Shut off the engine and let it cool, then remove all
hoses.
3. Place the throttle lever in STOP position.
WARNING!
Be sure lever is in “STOP”
position before you continue. If you start
engine without proper water supply connected,
you can damage pump.
4. Empty the pump of all pumped liquids by pulling
the recoil handle about 6 times. This should
remove most of the liquid in the pump.
NOTE: To protect the unit from freezing temperatures,
draw RV antifreeze (no alcohol) into the pump by
pouring the antifreeze into a 3–foot section of garden
hose connected to inlet adapter and pulling recoil
handle twice.
5. Store in a clean, dry area.
STORING THE ENGINE
See the Engine Owner’s Manual for instructions on
how to properly store the engine.
Figure 17 — Backflush the nozzle.