Generac Portable Products 1330-0, Руководство пользователя

Страница: 8 / 24

8
Generac Portable Products 2000PSI High Pressure Washer
Connect Hose and Water to Pump
IMPORTANT: You must assemble the wand and
attach all hoses before you start the engine. Starting
engine without all hoses connected and water
supplied will damage the pump.
• Uncoil the high pressure hose and attach one end
of the hose to the base of the spray gun. (Figure 5).
Tighten by hand.
• Attach the other end of the high pressure hose to
the high pressure outlet on the pump (Figure 6).
Tighten by hand.
• Before you connect your garden hose to the water
inlet, inspect the Inlet Screen (Figure 7). Clean the
screen if it contains debris or have it replaced if
damaged. DO NOT RUN THE PRESSURE
WASHER IF THE SCREEN IS DAMAGED.
• Run water through your garden hose for 30
seconds to clean out any debris .
• Connect the garden hose to the water inlet. Tighten
by hand (Figure 7).
• Turn ON the water.
• Squeeze the trigger on the gun until you have a
steady stream of water. This purges the pump
system of air and impurities.
CAUTION:
Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
• Attach the adjustable nozzle extension to the spray
gun. Tighten by hand (Figure 8).
Figure 5 — Connect High Pressure Hose to Spray Gun
Connect high pressure
hose here.
Figure 6 — Connect High Pressure Hose to Pump
Connect high
pressure hose here.
Figure 7 — Connect the Garden Hose to Water Inlet
and Turn ON the Water.
Inspect inlet
screen, do not use
if damaged, clean
if dirty.
Figure 8 — Connect Nozzle Extension to Spray Gun