Generac Portable Products 1330-0, Руководство пользователя

Страница: 9 / 24

9
Generac Portable Products 2000PSI High Pressure Washer
CHECKLIST BEFORE
STARTING ENGINE
If you have reached this point, look back over the
assembly to see if you have performed all of the
following.
• Make sure the handle and wireform are in place
and secure.
• Check for properly tightened hose connections
(high pressure and water supply).
• Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
• Check that oil has been added to the proper level in
the engine crankcase before trying to start the
pressure washer.
• Add the proper gasoline to fuel tank.
• Provide a proper water supply (not to exceed
140°F).
• Be sure to read the “Safety Rules” and “Operation
sections before using the pressure washer.
HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-270-1408 .
How to Start Your Engine
The best way to start your engine–powered pressure
washer for the first time is to follow these instructions
step–by–step. This starting information also applies
whenever you start the engine after you have let the
pressure washer sit idle for at least a day.
• Place the pressure washer in an area close enough
to an outside water source that can flow at a rate of
2.2 gallons per minute.
• Make sure the unit is in a level position.
• Check that the high pressure hose is tightly
connected to the spray gun and to the pump.
• Connect the garden hose to the water inlet on the
pressure washer pump and turn on the water .
WARNING!
Do not run the pump without the
water supply connected and turned on. You
must follow this caution or the pump will be
damaged.
• Position the nozzle in the low pressure mode
(nozzle slid forward) and squeeze the trigger on the
spray gun to relieve the air pressure caused by
turning ON the water. Water will flow out of the gun
in a thin stream. Continue to hold trigger until you
have a steady stream of water and no air remains in
the system. This will make it easier to pull start the
engine. Release the trigger.
• Engage the safety latch on the spray gun (Figure
9).
Figure 9 — Spray Gun with Safety Latch Engaged
Safety Latch