equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or televi-
sion reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Modifications not expressly approved
by the manufacturer could void the user’s
authority to operate the equipment under
FCC rules.
Changing the remote control
battery
The remote control battery can be changed
by turning the battery cover on the back of
the remote control anticlockwise. Use a small
screwdriver under the right side of the bat-
tery (see figure 4) to wedge the battery out.
Replace the battery with a similar CR2032
type battery. Insert the battery with the left
side first as shown in figure 4 and close the
battery cover.
Maintenance
There are no user serviceable parts inside
the subwoofer. Any maintenance of the unit
must only be performed by qualified service
personnel.
Guarantee
This product is supplied with two year guar-
antee against manufacturing faults or defects
that might alter the performance of the unit.
Refer to supplier for full sales and guarantee
terms.
Figure 4. Changing the remote control battery
EC Declaration of Conformity
This is to certify that the Genelec Active
Subwoofer 5051A conforms to the following
standards:
Safety:
IEC 60065:2001 + A1:2005 + A2:2010/
EN 60065: 2002 + A1:2006 + A11:2008 +
A2:2010 + A12:2011
EMC:
EN 55020:2007
EN 55013:2001 + A1: 2003 + A2: 2006
EN 61000-3-2:2006 + A1:2009 + A2:2009
EN 61000-3-3:2008
The product herewith complies with the
requirements of The Low Voltage Directive
2006/95/EC and EMC Directive 2004/108/EC
Signed:
Ilpo Martikainen
Position: Chairman of the Board
Date: 22-November-2011