9.0 - VEHICLE CODE PROGRAMMING
I
”).
f the system is to be managed via CAN BUS, it must be configured according to the vehicle on which it
is installed.
To help you understand the coding procedure, the following example shows how to configure a vehicle
with code 1-0-3 (which hypothetically corresponds to a “FIAT XXXXX
).
A separate leaflet, included in the alarm packaging, lists all the available vehicles
(codes are updated at packaging time).
Up-to-date information on supported vehicle models can be found at: www.gemini-
alarm.com (restricted access section
!
!
Connect the harness connectors to the relative connectors of the alarm unit.
.
Press and hold the button shown below until the LED lights up
Release the button, the LED switches off.
After a 3/4 seconds, the LED starts a flashing sequence; count the flashes.
In this case, press
“1”).
the button at the 1st flash (which corresponds to number
After 4 seconds, the LED starts blinking again.
Press
“0”).
the button at the 10th flash (which corresponds to
After another 4 seconds, the LED flashes the third sequence.
Press the button at the 3rd flash (which corresponds to number “3”).
Press
Press
Press
1ST
FLASH
10TH
FLASH
3RD
FLASH
3-4 seconds
PAGE 10 - INSTALLER MANUAL
The system has a
indicator that signals any wrong vehicle code inserted.
The code must range between 100 and 235 otherwise the LED on the unit blinks
repeatedly and the procedure is interrupted.
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times.
In this case there is no optical warning, the procedure is simply be interrupted.
In either case, repeat the whole procedure.
LED
