GEKKO GTO 22, Руководство пользователя

Страница: 135 / 148

When launching the boat, back the trailer so the fenders are just below the water line.
Start the boat and allow the engine to warm up for 1-2 minutes before backing off the
trailer.
IMPORTANT
The depth of the trailer while launching and loading may vary from ramp to ramp
depending upon the incline.
Loading Procedure TOP
To load the boat on the trailer, position the trailer in the water with approximately 1
inch of the top of the fender showing.
1. If equipped with Boat Buddy, set the Boat Buddy for loading by pulling trigger
or latch mechanism into “set” position.
2. Idle/coast the boat onto the trailer using as little power as possible, while
keeping it centered between the guide poles.
3. Power slowly forward until the bow softly touches the Bow Roller.
4. Winch hook must be attached to bow eye and tightened before trailering.
DO NOT Power onto the trailer during rough conditions! Once correctly positioned on
the trailer, switch off ignition.
DO NOT OVER POWER onto trailer or damage may occur to the boat and/or the
trailer!