GEISMAR MP.12, Руководство пользователя

Страница: 37 / 78

Ref. : 450100 FR P a g e
| 35
5.1.2 – Cleaning
Ensure the machine is kept as clean as possible. Equipment lifetime and proper
operation will depend on how carefully the machine is cleaned.
Clean the machine thoroughly using a clean cloth to remove any dirt deposited
on it, in particular near the moving parts. As a precaution, systematically wear
gloves to avoid injuring your hands.
Regularly clean the guide rollers and the support rollers. Clean on both sides of
the machine.
5.1.3 – Engine rotation speed
When leaving the factory, the carburettor is delivered with the
optimum setting corresponding to the barometric and climatic
conditions prevailing on the manufacturing plant site. For optimum
use of the machine, the engine speed must correspond to that
marked in chapter 2.3 Technical characteristics.
Apart from routine servicing during use, we recommend that you
have any carburettor repairs or adjustments carried out by GEISMAR
sales or troubleshooting operators. All carburettor adjustments must
be performed when the engine is heated. To perform these
adjustments, refer strictly to the manufacturer’s instructions.
Regularly check engine idling maximum rotation speed using an
electronic counter. A check must be run before putting into service
for the first time, as atmospheric conditions and altitude may
markedly modify this adjustment.
When checking or adjusting, the machine must be installed on the
work position on an assembly locked in place in order to measure
engine speed.
Too high or too low rotation speed may result in early wear of some
parts or even in serious operating incidents.
5.1.4 - Lubrication
Regularly lubricate the threadings of the various machine locking
levers.
For each week of use, fill the 4 grease guns Items
①
,
②
and
③
of the
machine.
Use one of the recommended greases (TOTAL: MULTIS EP 2, KLÜBER:
CENTOPLEX 2 EP) or any of the other greases complying with standard
DIN 51 354 or ISO.L.XBBFB.00 (00 grade viscous spray grease for
heavily loaded gear. Operating temperature ranging from – 20°C to +
120°C).
The spindle thrust bearing is life-lubricated with CASTROL Longtime
PD2 synthetic grease. In case of filling after an operation, contact us
or use NLGI.2 grade grease, with an operating temperature range
from -20 to +150°C and satisfying standard MIL.G23827A.
Cleaning is performed with the engine cooled
cooledengine
1
2
2
3