Gehl SL3635, Руководство оператора

Страница: 55 / 82

Spark Arrestor Muffler
Important:
The loader is factory-equipped with a spark arrestor style
muffler. Muffler maintenance is required to keep it in working condition.
Refer to local laws and regulations for spark arrestor requirements.
1.
Stop the engine, open the rear door and engine cover.
2.
Remove the plug from the bottom of the muffler.
3.
Block the outlet of the muffler with a non-combustible material.
4.
Start the engine and run it for 10-15 seconds.
5.
Stop the engine and remove the blockage.
6.
Put anti-seize coating on the plug.
7.
Reinstall and tighten the plug.
Alternator/Fan Belt
Refer to the separate engine manual for setting proper belt tension. If the belt
is worn, cracked or otherwise deteriorated, replace the belt following the
procedure in the separate engine manual.
Seat and Restraint Bar Switches
Electrical switches in the seat and restraint bar must be closed (operator
sitting in the seat and restraint bar lowered) to complete the circuit and start
the engine.
Bucket Cutting Edge
The bucket cutting edge should be replaced when it is worn to within 1"
(25 mm) of the bucket body.
Wheel Nuts
Wheel nut torque must be checked before initial operation and every two
hours thereafter until the wheel mounting hardware torque setting stabilizes
at the recommended setting 120-130 ft-lbs (161-175 N·m). When tires are
removed and replaced, this procedure must be repeated.
Tires
Rear tires usually wear faster than the front ones. To keep tire wear even,
rotate the tires from front to rear and rear to front.
It is important to keep the same size tire on each side of the loader to prevent
excessive wear on tires, chain and chaincase, or other damage. If different
sizes are used, each tire will be turning at different speeds, causing excessive
wear.
908268/BP0904 52