Gehl SL3635, Руководство оператора

Страница: 38 / 82

Changing Attachments
To prevent unexpected attachment release from the
hitch, be sure to properly secure the hitch lock pins by rotating the latch
levers to a horizontal position.
The skid loader features a All-Tach™ attaching mechanism (hitch) for
mounting a bucket or other attachment. Two latch levers secure the
attachment.
Connect Attachment
1. Rotate the latch levers to a
vertical position to fully retract
the latch pins.
2.
Start the loader engine and
make sure the lift arm is
lowered and in contact with the
loader frame.
3.
Align the loader squarely with
the back of the attachment.
4.
Tilt the hitch forward until the
top edge of the hitch is below
the flange on the back side of
the attachment and centered
between the vertical plates.
5. Slowly drive the loader forward and, at the same time, tilt the hitch back to
engage the flange on the back side of the attachment.
6. Stop forward travel when the flange is engaged, but continue to tilt the
hitch back to lift the attachment off the ground.
7. Exercise the
MANDATORY SAFETY SHUTDOWN PROCEDURE
(page 7).
8.
With the loader engine
OFF
, leave the operator’s compartment and rotate
the latch levers to a horizontal position to fully engage the latch pins.
Important:
To check that the attachment is properly installed, apply down
pressure to the attachment prior to operating.
35 908268/BP0904
Fig. 16: Hitch - disengaged
1. Latch Levers
2. Latch Pins
1
2 2
1
WARNING