page | 27
Advanced Operation
RS-232 Commands
Command
Description
#aspect
Sets the aspect ratio of the output signal
#autolock
Enables / disables automatic Genlock
#blacklev
Sets the black level of the output signal
#bright
Sets the brightness of the specified color component
#cleanaper
Defines an area within the production aperture
#colrange
Sets the color range to limited or full
#contrast
Sets the contrast of the specified color component
#devtype
Returns the device type that is connected
#deversion
Displays the current hardware and software version
#edid
Programs the EDID PROM
#enhance
Sets the enhancement detail of the output signal
#extract
Zooms-in on specified are of the input video signal
#filmmode
Enables / disables film mode
#gamma
Sets the gamma correction mode
#genoffset
Sets the genlock offset
#input
Sets the input timing for the source signal
#insel
Switches between HDMI and DVI inputs
#key
Used to emulate the IR remote control unit using RS-232
#language
Set the OSD to the specified language
#linkconf
Sets the link configuration
#motionthres
Sets the intraframe motion detection threshold
#noisereduc
Sets the noise reduction value
#noisethres
Sets the noise threshold value
#output
Sets the output resolution of the output signal
#pattern
Displays the specified test pattern
#rb
Reboots the scaler
#remotechan
Sets the IR channel of the scaler
#restore
Resets the scaler to factory-default settings
#save
Saves all current settings to the PROM
#sizepos
Sets the size and position of the output signal
#through
Defines an area of the output image with cropping
#version
Returns the current hardware and firmware information
