page | 6
Installing the Battery
The IR remote control unit ships with two batteries. Only one battery is required for
operation. The second battery is a spare. Use only 3V CR2032-type batteries.
1. Remove the back cover the IR Remote Control unit.
2.
Insert the included battery into the primary battery slot. The positive (+) side of the
battery should be facing up.
3. Replace the back cover.
Setting the IR Channel
In order for the included IR remote control to communicate with the HDMI and DVI to
3GSDI Scaler, the IR remote control must be set to the same channel as the scaler.
Use the
#remotechan
command to set the IR channel of the scaler.
Getting Started
IR Remote Control Unit
WARNING:
Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
DIP switches
Remote Channel 2:
Remote Channel 3:
Channel 0 (default):
Remote Channel 1:
1 2
ON
1 2
1 2
ON
1 2
ON
1 2
ON
NOTE:
An Activity Indicator that flashes quickly while holding down
any one of the buttons indicates a low battery. Replace the battery
as soon as possible
.
