GE XDP-H2, Руководство пользователя

Страница: 59 / 96

Advanced Programming 5-3
January 2008
Configuring the Display
(cont.)
Note:
“0:Analog Output” is also available in the above list box.
To select the desired output(s), complete the following steps:
1.
Use the [
S
] and [
T
] keys to highlight a specific system output.
For this example, make sure that
[0:Display]
is selected as one of
the outputs to be displayed.
2.
Use the [
W
] and [
X
] keys to select “Add” or “Remove” and press
the
[ENTER]
key to change the status of the selected output. An
output is selected if an asterisk (*) appears to its left.
3.
When all of the desired outputs have been selected, use the [
W
]
and [
X
] keys to select “OK” and press the
[ENTER]
key.
From 1:Cfg The currently active range is
listed. Press
[ENTER]
to select
this range. (H2/AIR is used
here as an example.)
H2/AIR
From 1:Cfg H2/AIR A list of available units is
shown. Use the [
S
] and [
T
]
keys to select the desired units
and press
[ENTER]
.
mA
pcnt
From 1:Cfg H2..pcnt A list of the available output
devices is shown. Follow the
instructions below to select the
desired outputs.
*0:Display
*0:Fault Alarm
Add Remove OK Cancel
From 1:Cfg H2/AIR Press
[ESC]
three times to
return to the main menu. Then,
press
[ESC]
again to return to
run mode.
mA
pcnt
1 H2/AIR
The selected display is shown.
[Notice that the padlock no
longer appears, as the menus
are now unlocked.]
18.73 mA