GE Responder AED, Руководство по обслуживанию

Страница: 27 / 37

SECTION 3 – MAINTENANCE AND TROUBLESHOOTING
Page 26 of 35 © 2010 General Electric Company 2022100-201 Rev C
AUTHORIZED REPAIR SERVICE
The AED has no user-serviceable internal components. Try to resolve any maintenance issues with the AED
by using the Troubleshooting Table presented in this chapter. If you are unable to resolve the problem,
contact Customer Service.
WARNING: Shock Hazard
Do not disassemble the AED! Failure to observe this warning can result in personal injury or death.
Refer maintenance issues to authorized service personnel.
Note: The warranty will be void upon unauthorized disassembly or service of the AED.
DEFIB TESTING
• Required Equipment: Dynatech-Nevada Impulse 3000 Defib Analyzer or equivalent
• Method:
Note: Detailed instructions for using the ServiceLink software can be found in the ServiceLink
manual provided on the ServiceLink software CD.
1. Use ServiceLink to ensure the AED is set to a known protocol:
#1 Standard (High
– Default value)
200VE 300VE 300VE
#2 Standard (Low)
200VE 200VE 300VE
#3 Ultra Low
Energy B
150VE 200VE 200VE
#4 Ultra Low
Energy A
150VE 150VE 200VE
#5 Non-Escalating
Low Energy
200VE 200VE 200VE
2. Set the defibrillator tester to output a Ventricular Fibrillation ECG.
3. Power on the AED.
4. Connect the AED defibrillator pads to the defibrillator tester.
5. The AED should automatically analyze and charge.
6. Press the Flashing shock button on the AED.
7. Record the energy delivered as displayed on the defibrillator analyzer.
8. Repeat for a total of three shocks.
9. Replace
pads.
10. Close the lid and verify that the indicator turns green after approximately 5 seconds.
•
Acceptance Criteria:
150VE Shock – Acceptable range is: 95J to 196J
200VE Shock – Acceptable range is: 126J to 260J
300VE Shock – Acceptable range is: 170J to 351J