GE Profile PGS968, Техническое обслуживание руководство

Страница: 31 / 80

– 31 –
Remove the six ¼-in. hex-head screws that hold 5.
the heat barrier to the inner door. Remove the
heat barrier.
Remove the two 1/4-in. hex-head screws (1 on 4.
each side) that attach each retainer to the heat
barrier.
Remove the insulation and the inner glass 6.
assembly from the inner door.
Inner Glass Assembly
Assembly Notes
When assembling, make sure the hinges are parallel
to each other and perpendicular to the door liner. If
not, the hinge may bind on the receiving channel of
the door. If the new hinge is not in the cocked and
locked position after installing, place the bottom of
the door against a
fi rm, protected surface and push
the hinge arm down to the cocked position. Pull the
hinge lock back against the door liner surface to
lock the hinge in this position.
Air enters the door assembly through large slots in
the bottom and
fl ows upward between the inner
and outer assemblies, exhausting through slots
in the top of the door. DO NOT INSULATE THIS AIR
CHANNEL.
Arrows on the side of the inner glass assembly
indicate the direction in which the inner oven door
glass is installed. The arrows should be pointing
toward the oven cavity.
OVEN
Door Gaskets
The gasket forms a complete seal around the front
edge of the oven liner and the inner door panel. The
door gasket is attached to the inner door panel by
spring clips. When removing the gasket, pull the
ends of the gasket out of the slots at the bottom
of the door. Place a
fi nger under the gasket beside
each clip and pull straight up.
( Continued next page )