– 41 –
Note: The sensor and sensor wiring can be checked
at the power board assembly. Check for a resistance
value of approximately 118
Ω
resistance between
the 2 yellow wires located on the wire harness
located at J79.
On the inverter board, check for an approximate
5.
resistance value of 6 ohms
between any two of
the three terminals:
A to B (Blue to white) - 6
•
Ω
A to C (Blue to red) - 6
•
Ω
B to C (White to red) - 6
•
Ω
B
C
A
J79
(Continued Next Page)
To remove the motor:
Remove the belt. (See
1.
Belt
.)
Remove the
2.
1
/
2
-in. bolt from the threaded plate
that holds the motor arm to the outer tub.
Slot
Plate
Motor Arm
Note
The threaded plate can fall out of the recessed
•
slot in the motor mount. Ensure this plate is
reinserted in the slot upon reassembly.
When reinstalling bolt, apply Locktite (Part #
•
WX5X1005) to bolt threads. Ensure motor arm
is at lowest position under motor bolt before
tightening.
