– 33 –
Caution:
To prevent damage to the cooktop, do not
raise the cooktop more than 45 degrees.
8. Lift the front of the cooktop panel upward
approximately 4 inches.
9. Raise the rear of the cooktop slightly to
disengage the hinge slots from the hinge pins.
10. Lift the cooktop up and over the hinge pins, and
remove the cooktop panel.
Rear Cover Removal
To remove the rear cover:
Disconnect power to the range.
1.
Pull the range out from its installation.
2.
Remove the 1/4-in. ground screw and ground
3.
wire from the back of the range.
Remove the 1/4-in. hex-head screw and
4.
terminal cover.
Remove six 1/4-in. hex-head screws that attach
5.
the panel to the range.
Note:
When installing the rear cover, insert left side
of cover under tab before installing screws.
Ground Screw
Tab
Ground Wire
Control Panel Rear Cover
To remove the rear cover:
Disconnect power to the range.
1.
Pull the range out from its installation.
2.
Remove three 1/4-in. hex-head screws that
3.
attach the panel to the range.
Note:
When installing the control panel rear cover,
insert both tabs in the slots located in the back of
the range before installing screws.
Tab
Tab
Hinge Pin
Hinge Slot
