GE NX-10, Руководство по установке

Страница: 65 / 162

NX-10 Expander Installation Guide
65
8.
The keypad beeps once to accept the change and returns to Outputs .
Table 9. NX-320-I output events
# Event # Event # Event
Alarms Arm/disarm Misc
17 Alarm Memory 21 Armed 32 Code Entry
Tests 22 Disarmed 7 Program Mode
3 Dyn Battery Test 23 Ready to Arm 0 Always On
Tampers 18 Entry Keypads
25 Fire LED 19 Exit 29 Keypad Fire
11 Smoke Det Reset 20 Entry or Exit 30 Keypad Medical
8 Over-current 24 Not Ready to Arm 31 Keypad Panic
9 Box Tamper Sirens 28 Keypad Beeping
10 Siren Tamper 12 Burglary Siren 27 Chime
26 Fire Trouble 13 Fire Siren Communications
1 Mains Failure 14 Any Siren 4 Listen-in
2 Low Battery 15 Fire Sir Steady 5 Line Seizure
16 Any Sir Temporal 6 Phone Line Fault
Note: Faults on outputs are restored after a valid PIN is entered at the keypad.
Configuring features
You can configure testing and reporting features for the NX-320-I power module. The following
example enables a battery test which lasts for 60 minutes and sends a report to the central station
when a low battery condition occurs.
1 . Navigate with the ½¾ keys to NX-320-I Power Modules>Power Module 84>Feature Select
and press OK .
2 . Scroll to Battery Test>Enabled and press OK .
3 . The keypad beeps once to accept the change and returns to Battery Test .
4 . Scroll to Battery Test Time and press OK .
5 . Select 60 min. and press OK . The keypad beeps once to confirm the change and returns to
Battery Test Time .
7 . Scroll to Reports>Low Battery>Yes and press OK .
8 . The keypad beeps once to accept the change and returns to Low Battery .