GE LOGIQworks, Базовое руководство по обслуживанию

Страница: 210 / 420

GE M
EDICAL
S
YSTEMS
D
IRECTION
5184024-100, R
EVISION
5 LOGIQ
WORKS
B
ASIC
S
ERVICE
M
ANUAL
3-144 Section 3-5 - Configuration
3-5-4-7 DICOM
(cont’d)
-
Max. Number of Associations:
Set the maximum number of simultaneous incoming
connections LOGIQworks should be able to handle. (Default: 4)
-
Receive time-out (s):
The time after which LOGIQworks will report an error if no command
is sent to the system after another system has initiated a connection with it. (Default: 60)
•
DICOM Send
-
Split DICOM Series:
This option is used when studies are sent from LOGIQworks in DICOM
3.0 format to other systems. If enabled the sending LOGIQworks system will use separate
DICOM associations for each series contained in the study that is being transmitted. This
option should only be used for systems that inadvertently "mix" images from different series.
(Default: not checked)
-
Request Explicit VR:
This flag can be used to indicate whether the system should request
the explicit VR transfers syntax when sending data to other systems. If the remote system
declines the explicit VR syntax, the study will be sent in implicit VR mode. (Default: checked)
• DICOM General
- PDU Packed Size (bytes):
Specifies the size of the packets that LOGIQworks uses to send
data. Typically you should leave this at the default value since it works well for all
LOGIQworks stations. If the value is too high, overall transmission speed will be reduced. A
figure that is too low may mean that additional packets need to be used to send data, again
redoing performance. (Default: 16384)
3-5-4-8 Transmit
View and adjust settings that control the 'transmission' behavior of the Connection Service.
1.) Select
Configuration
>
Connection Service...
from the Data Selector menu.
2.) Select the Transmit tab from the Connection Service Properties page.
All but the first two settings apply to transmissions in both AMI and DICOM formats.