LOGIQ 7/LOGIQ 7 Pro Quick Guide
Direction 5307393-100 Rev. 1
2
Power Off
To power down the system:
1.
Enter the scan screen and lightly press the
Power
On/Off
switch at the front of the system once. The
System-Exit window is displayed.
2.
Using the
Trackball
or
Tab
key, select
Shutdown
.
The shutdown process takes about 30 seconds (the
Power On light is green) and is completed when the
control panel illumination is turned off (the Power On
light is amber).
NOTE: DO NOT select Exit for Shutdown. Exit is
only available to Service representative.
3.
Disconnect the probes.
Clean or disinfect all probes as necessary. Store
them in their shipping cases to avoid damage.
Standby Mode
Standby Mode pauses the system without completely
shutting down and restarting the system. This is
particularly useful for portable exams.
To activate Standby Mode,
1.
Press the
Power
switch at the front of the system
once. The System-Exit window is displayed.
2.
Select Standby. The monitor immediately blacks out
while the Touch Panel and keyboard turn off.
Wait at least one minute to bring the system out of
standby mode as the system starts the standby
process after the monitor blacks out.
3.
To exit Standby Mode, press and immediately
release the Power switch.
Starting an Exam
You need to select a pre-configured dataflow that sets up
the ultrasound system to work according to the services
associated to the dataflow.
1.
Select your Operator Login and type in your
Password:
2.
Press OK.
3.
Fill in the New Patient menu as described on Page 3.
OR,
If the patient name is on the patient record list,
1.
Trackball
to the patient’s name to highlight the
name, (or perform a search to locate the patient)
then press
Select Patient
.
