GE JSP60GN, Инструкция по использованию, уходу и установке

Страница: 19 / 48

our non-stick coated griddle provides an extra-large cooking surface
for meats, pancakes or other foods usually prepared in a frying pan or
electric skillet. You can also use the griddle as a warming tray by using
a low-heat setting.
How to Assemble the Griddle Accessory
1. Be sure the controls OFF.
2. the reflector in the grease well.
3. Grasp the element with both hands near the
plug. Keeping the element as nearly horizontal
possible, push the
firmly into the receptacle
ensure complete contact.
4. Place the griddle into the opening in the cooktop
with the 2 holes toward the front the
cooktop (nearest the controls) shown in this
illustration.
NOTE: When properly placed, the griddle sits
slightly above the cooktop. This. and the open
spaces on the sides
rear the griddle, prevent
excessive temperatures.
Using the Griddle
The non-stick griddle must be preconditioned
before using it for the first time. To precondition,
first wash the griddle in soap and water and dry. Then
use a paper towel apply a small amount of cooking
oil the griddle. Remove excess
with a
paper towel.
Preheat the griddle as recommended in the Griddle
Cooking Guide. After preheating for the recommended
amount of time, apply a
of’ oil or butter.
Do not overheat the griddle. Leaving the griddle
at HI for more than 10 minutes without food can
damage the non-stick coating.
When using the griddle, the blower system is
automatically controlled.
Always turn on both sections of the heating
element under the griddle. Heating only part of the
griddle may warp it and will result in non-uniform
cooking. Because the heating element under
griddle is divided, can vary the temperature on
front and rear sections.
How to Remove Griddle Accessory
Be sure the controls are OFF and the griddle is cool.
To remove the griddle:
1. Lift the back edge of the griddle a bit to let any
excess fat or drain.
2. Remove the griddle.
3. Grasp the element with both hands on either side
of the plug.
4. Raise the opposite side the element just enough
to clear the well, then away from the receptacle,
The element will not sit level when replaced if
it is forced too far upward when removed.
5. Remove the 2 reflector plates.
19