GE JP383, Инструкция по использованию, уходу и установке

Страница: 34 / 44

Preparing for
cooktop
designed
to look best when centered
in a cabinet same width.
The exhaust vent beneath the cooktop must be
located studs or floor joists so that
maybe properly
At least 6“ must be allowed side edges
of cooktop and adjacent
Avoid placing above the cooktop
unit,
if possible, in order to reduce the
caused by reaching overheated surface units.
are placed over the cooktop, the risks
can be reduced by a range hood that
projects a of 5 inches
beyond the bottom of the
is used above a
30” clearance between the cooking
surface the bottom of any unprotected
clearance
cooktop and is
less than 30”, bottom must be
with flame retardant at least 1/4”
thick, covered with 28 gauge sheet steel or
0.020” thick copper, Clearance between cooktop
and protected
must BE
24”.
of a fisted microwave
oven or cooking over the cooktop
conform to the initiation instructions packed
with that
A
15”
minimum must be kept from the side
edge of cooktop to the bottom of any
not above cooktop.
clearance is less
than
15”, adjacent cabinets should beat least
6“ from side edge of cooktop.
34
Step 2
Preparing
cooktop designed to fit into a variety
of cabinets. some cabinets may require
modifications.
a
a
some cabinets, the sides may need be scooped
or cut down 2“ as shown, and corner braces
removed in order to accommodate the
75 cm. and cm. European
the back panel may need to beat
5“ to accommodate
unit
a or
type
a peninsula or island type cabinet, the sides
may need to be scooped or cut down, and the
corner braces removed in order to accommodate
the unit.
5“
for European
Step
3
Rough of
FUSE OR OPEN
BEFORE
an approved junction box within shaded
area shown in diagram. Junction box must be at
least
below top of cabinet.
Run conductors from residence wiring to
junction box according to codes.
g“
4“