GE JKS10, Техническое обслуживание руководство

Страница: 30 / 66

– 30 –
2. Remove the four T-15 Torx screws (2 on each
side) that attach each door hinge to the inner
door. Carefully turn the door over and remove
both door hinges.
Remove the four ¼-in. hex-head screws that 3.
attach the glass and side brackets (glass closet
to the outer door glass) to the inner door.
Remove the two ¼-in. hex-head screws that 4.
hold the heat de fl ector to the heat barrier.
Remove the four T-15 Torx screws (2 on each 4.
side) from the outer door assembly.
Caution: Care must be taken if reinstalling the door
handle. Over-tightening the screws can damage the
handle. Hand-tighten the screws and make sure the
handle
fi ts snugly to the door panel. (Do not use an
electric driver.)
To replace the inner door assembly:
Remove the outer door assembly. (See 1.
Door
Assembly
.)
( Continued next page )
To remove the outer door assembly:
Remove the door. 1.
Place the inner door assembly, gasket side up, 2.
on a protective surface.
Remove the three T-15 Torx screws from the 3.
bottom of the outer door assembly.
Note: The inner door assembly is heavier than the
outer door assembly.
Separate the inner door assembly from the 5.
outer door assembly.
Remove the four ¼-in. hex-head screws and 6.
spacers that hold the door handle to the outer
door assembly.
Door Shown with Inner Door Assembly Removed
Outer Door Assembly