figure below shows the recommended
initiation relationship of the ranges to the
of the surrounding structure.
Please note the following:
1.
The
back of the range maybe
against the rear
of the structure.
2.
ranges conform to
requirements for
spacing from the range to adjacent
above
countertop level. However, to
reduce possible scorching
and to
potential
under
surface unit use conditions such as high heat or
no pans, a minimum of 2“ spacing should be
provided on both sides of the
3. To
the
of reaching over
heated surface units, cabinet storage space
located above the surface units should be
avoided. a cabinet is to be provided, the
be reduced by
a range hood that
projects
a minimum of 5“ beyond
the bottom of the cabinets.
This range
must be properly secured to the
floor by using the included anti-tip
and
screws.
to
the brackets
the range to
tip over if excessive
weight is placed on an open door or if a
upon it. Serious injury might result from
hot
or from the range
Refer
to the instructions below for proper
the range is ever moved to a different
location, the anti-tip brackets must
be
moved and
with the range.
Tools
5/16”
or
Head Screwdriver
Adjustable Wrench
Electric
& 3/16” Diameter Bit
3/16” Diameter Masonry
in concrete)
Brackets
to the floor at the back of
range
to hold
rear leg levelers. When fastening to
floor, be sure that screws do not penetrate
wiring or plumbing. The screws provided
work in either wood or concrete.
1. Unfold the paper template and
it
on
floor with the back and side edges positioned
where the back and sides of the range
be
when
the diagram to
the brackets
is not
2. Mark on the floor the location of the 4
holes shown on the
For
3/16” diameter
holes,
1/2” deep
be
into the
3. Remove
template and place the brackets
the floor with turned up flanges to the
up the holes in the brackets with marks on
he floor and attach with the 4 screws provided.
must be secured to a
to masonry floor, first
3/16”
holes using a concrete bit
the range if necessary, by adjusting the
leg levelers with a wrench.
of 1/8” is required between the bottom
the range and the rear
feet)
Shale the range into place making sure the
ear legs are trapped by the ends of the brackets.
range may need to be shifted
to one
ideas it is being pushed back to
the rear
to
with the brackets. Remove the
drawer to inspect brackets or grasp the
rear edge of the range and
attempt
it forward to make sure the range is
anchored.
Edge of
or
I
I
33
Содержание JCP67
Страница 3: ......
Страница 4: ......
Страница 6: ...FwmS OF YOm WGE i JCP67 6 11111 111111 JCS57 4 ...