GE JCP67, Инструкция по использованию, уходу и установке

Страница: 25 / 36

a Clean Cycle
1.
When the
Oven Cleaning Light is off,
turn the NOTE: you wish to start and stop clean at a later
OVEN knob to OFF. time than shown on the push in and turn the
2. Turn the OVEN SET knob to OFF. The door
to the time you wish to start. Add the
will unlatch and signal lights
hours needed for the cleaning to this start time, then
will be off.
push in and turn the STOP to the
desired time. The oven turn on
and off at the set times.
To Stop a Cycle
After setting the oven for a clean cycle,
do not try to open the oven door as this can damage
the automatic door-locking system.
If you want to use the time before a clean
cycle is done, turn the OVEN SET and OVEN
knobs to the oven cools, the
door will unlock and can then be opened.
Should the oven door become locked
to
open the door, turn the OVEN SET
knob back to CLEAN, push in and the STOP
past the time of day. Wait one minute then turn
the OVEN SET knob to OFF. Wait a few seconds and
the door may be opened.
If the door latch finger becomes positioned so as
to keep the oven door from closing
the way, this
can be corrected as follows:
Make sure the oven is
●
Open the oven door, turn the SET knob to
CLEAN. Push in and advance the STOP dial past
the time of day. Push in the oven interlock button
is at the right top of the oven door opening)
and hold the button in for about 15 seconds.
●
Next, turn the OVEN SET knob to OFF and again
push the oven interlock button for about 15 seconds.
The latch finger, being motor driven,
turn so the
oven door may be closed.
Questions and Answers
Q.
oven clock is not set the correct time
of day, can I my oven?
A. If the clock is not set to the correct time of day
you not be able to set a delay clean to end
at a specific time.
Q. or sound I hear
during cleaning normal?
A. Yes. This is the sound of the metal heating and
cooling during both the cooking and cleaning
functions.
Q. My oven shelves do not easily.
is the matter?
A. After many cleanings, oven shelves may become
so clean they do not slide To make the
shelves slide more after each self-cleaning
function dampen fingers with a amount of
cooking and rub over sides of shelf
where they shelf supports.
Q. causes the on the enameled
surface of my oven?
A. This is a resulting from heating
and cooling during cleaning. These lines do not
how your oven performs.
Q. Should there be any odor during the cleaning?
A. Yes, there will be an odor during the first few
cleanings. to wipe out might
a strong odor when cleaning.
Q.
do I have ash left in my oven cleaning?
Some types of soil will leave a deposit which is
ash. It can be removed with a damp sponge or cloth.
Q. should I do if excessive smoking occurs
during cleaning?
A.
is caused by Turn the oven off.
Open the windows to rid the room of smoke. Wait
until the oven has cooled and the word “LOCK” is
off in the display. Wipe up the excess
and reset
the clean cycle.
Q. Can I use commercial oven cleaners on any part
of my oven?
No cleaners
or coatings be used around any
part of this oven. If you do use them and do not
rinse the oven with water, wiping it
absolutely clean afterwards, the residue
the oven and damage parts the next
time the oven is cleaned.
Q. My oven have become gray after the
cycle. this normal?
A. Yes. After the self-clean cycle, the shelves may
lose some luster and change to a deep gray color.
Q. won’t my oven clean even
though I have set the time and clean knobs
A. to be sure that your is set to the
same time as the oven