BEFORE YOU BEGIN
Read these instructions completely and
Save these instructions for the
inspectors use.
Observed governing codes
and ordinances.
NOTE TO
these
instructions with the
after
is completed.
this Use and
Guide and
for
use.
REQUIREMENTS
This
maybe
connected by
of
permanent
or power supply
cord
It the personal
of the customer
to contact a
technician to assure that
the
initiation is adequate and is in
conformance
the National Electrical Code
and
codes and ordinances.
MUST BE
ONLY.
wire must
not be used to avoid
connections.
POWER SUPPLY CORD
This
maybe connected by means of a
power supply cord kit.
a power supply cord
kit rated at 125/250 volts minimum,
40
amps
and marked for use with ranges
be
used. Cord must have 3 conductors,
home initiation or area where
codes do not permit grounding through
a 4 conductor power
cord kit rated at
125/250
minimum, 40
and
marked for use with ranges
be used.
Terminals on end of wires must be either closed
loop or
spade lugs with upturned ends.
Cord must have strain
WITH
POWER SUPPLY CORD
Some models may be equipped with a factory
connected 3 conductor power supply cord.
home initiation or area where local
codes do not permit grounding through neutral,
a 4 conductor power supply cord kit rated at
125/250
minimum, 40
and
investigated for use with ranges
be used.
on end of wires must be either closed
loop or
spade lugs with upturned ends.
This
is
with the
terminal connected to the frame.
1.
codes permit
of
grounding conductor to the
wire of the copper power supply cord:
Remove the screws and raise the terminal
block cover
part of the back wire cover).
B.
terminal nuts are taped to the frame
below the terminal block
Do not loosen
nuts.
C. Connect the
wire of the copper
power supply cord to the center
colored
of the
block and connect the
outer
to the outer
See
1.
Ring type terminals must be used on copper
power supply cord wires.
D. Replace the terminal block cover.
FIGURE
31
Содержание JCP67
Страница 3: ......
Страница 4: ......
Страница 6: ...FwmS OF YOm WGE i JCP67 6 11111 111111 JCS57 4 ...