❑✎
Lift-Off Oven Door
The
oven door is removable,
but it is heavy. You may need
help removing and replacing the
door. Do not lift the door by the
handle. This can cause the glass
to break or can cause damage to
the door.
To remove the door, open it a
few inches to the special stop
position that will hold the door
open. Grasp firmly on each side
and lift the door straight up and
off the hinges.
CARE
AND CLEANING
(continued)
NOTE: Be careful not to place hands between the
hinge and the oven door frame
as
the
hinge
could
snap back and pinch fingers.
To replace the door, make sure the hinges are in the
special stop position. Position the slots in the bottom
the door squarely over the hinges. Then lower the
door slowly and evenly over both hinges at the same
time. hinges snap back against the oven frame, pull
them back out. If the oven door is crooked, push
down on the high corner to straighten it.
TO CLEAN THE DOOR:
Inside of the door:
Because the area inside the gasket is cleaned during
the self clean cycle, you do not need to clean this by
hand. Any soap left
the liner causes additional
stains when the oven is heated.
outside the gasket can be cleaned with a
scouring pad.
●
Do not rub or clean the door gasket—the fiberglass
material of the gasket has an extremely low
resistance to abrasion. An intact and well-fitting
oven door gasket is essential for energy-efficient
oven operation and good baking results. If you
notice the gasket becoming worn, frayed or damaged
in any way or if it has become displaced on the door.
you should have it replaced.
NOTE: The gasket is designed with a gap at the
bottom to allow for proper air circulation.
Inside Gasket
‘/
I
of the door:
Use soap and water to thoroughly clean the top,
sides and front of the oven door. Rinse well.
You may also use a glass cleaner to clean the glass
on the outside of the door. To avoid water marks on
the inside of the glass door, do not let water drip in
the vent openings.
●
Spillage of marinades, fruit juices, tomato sauces
and basting materials containing acids may cause
discoloration and should be wiped up immediately.
When surface is cool, clean and rinse.
●
Do not use oven cleaners, cleansing
or
harsh abrasives on the outside of the door.
Oven Light Replacement
(on some models)
CAUTION: Before replacing your oven light bulb,
disconnect the electric power for your range at the
main fuse or circuit breaker panel or pull the plug.
sure to let the
cover and bulb cool completely
before removing or-replacing them. When in use, light
bulbs can become warm
to break if touched
with a moist cloth or towel. W-hen cleaning, avoid
touching warm
with cleaning cloths if the light
cover is removed.
The
light
is
covered with a removable
glass cover which is held
in place with a wire. Remove
the oven door, if desired, to
reach the cover easily.
To remove:
●
Hold your hand under the cover so it doesn’t fall
when released. With fingers of the same hand,
firmly push back the wire cover holder. Lift
the cover.
DO NOT REMOVE ANY SCREWS.
●
Replace bulb with 40-watt home appliance bulb.
To replace cover:
●
Place it into the groove of the light receptacle. Pull
the wire forward to the center of cover until it snaps
in place. When in place, the wire holds the cover
firmly. Be certain the wire is in the depression in the
center of the cover.
o Connect electric power to the range.
28
.
cover
holder
Содержание JBP22
Страница 37: ...NOTES 37 ...
Страница 38: ...NOTES 38 ...
