GE Interlogix 0150-0265A, Руководство пользователя

Страница: 12 / 18

GE Interlogix ProBridge Gateway
12 0150-0265A / August 2003
Source 0x00-0xFD keypad address <= Impac Mux/DVMRe
Camera number Mapped camera: 32 Cameras/Zone
Pan information 0x00: No Pan movement; 0x01 to 0x20: Pan Left at speed 1
to 32...
Tilt information 0x00: No Tilt movement; 0x01 to 0x20: Tilt Down at speed to
32...
Zoom information 0x00: No Zoom; 0x80+(0x01 to 0x20): Zoom In at speed 1 to
32...
Checksum 2’s complement
4.1.3.2 I
RIS AND
F
OCUS
(No Speed Values)
There is a motor start and motor stop command associated with each of the 4
functions to be controlled:
Iris Open, Iris Close, Focus Near, Focus Far . A
message is generated each time one of these four keys are pressed or released.
The ProBridge Gateway converts these messages to 312 messages as follows:
Port 0: Example with Iris Close (Start) on WaveReader
Motor Message format:
Synchronization 0xFF
Length 0x07
Message type 1 0x09
Message type 2 0x05
Destination Impac Mux/DVMRe
Source Impac Mux/DVMRe
Camera number Camera connected to Mux/DVMRe (00-0F)
Motor command Iris Close Start (Impac motor command)
Checksum 2’s complement
Port 1: Iris, Focus message at KTD405
Message format:
Synchronization 0xFF
Length 0x07
Message type 1 0x20 Digiplex message
Message type 2 312 command code
CMD312_IRIS_CLOSE(C) (Start)
Destination Mapped camera: 0x80-0xFD* 0x80 + camera # high byte
Source 0x00-0xFD keypad address <= Impac Mux/DVMRe
Camera number Mapped camera: Camera (site) # low byte
“Monitor “ value 0 (General command parameter)
Checksum 2’s complement
4.1.3.3 M
OUSE
T
RAK
C
OMMAND
:
Mapped address only. Nothing else has been changed.
4.1.3.4 A
UX
:
Not available at this time.