DRYER EXHAUST TO RIGHT, LEFT* OR
BOTTOM CABINET
WARNING -
BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES.
Installation Instructions
7
7
BATHROOM OR BEDROOM INSTALLATION
7KHGU\HU0867EHYHQWHGWRWKHRXWGRRUV6HH(;+$867
,1)250$7,21VHFWLRQ
• The installation must conform with local codes or, in the
absence of local codes, with the NATIONAL ELECTRICAL
&2'($16,1)3$12
MOBILE OR MANUFACTURED HOME
INSTALLATION
,QVWDOODWLRQPXVWFRQIRUPWRWKH0$18)$&785('+20(
&216758&7,21 6$)(7< 67$1'$5' 7,7/( 3$57
RU ZKHQ VXFK VWDQGDUG LV QRW DSSOLFDEOH ZLWK
$0(5,&$1 1$7,21$/ 67$1'$5' )25 02%,/( +20(
$16,1)3$12%
• The dryer MUST be vented to the outdoors with the
termination securely fastened to the mobile home
VWUXFWXUH6HH(;+$867,1)250$7,21VHFWLRQ
• The vent MUST NOT be terminated beneath a mobile or
manufactured home.
7KHYHQWGXFWPDWHULDO0867%(0(7$/
• Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
• See section 2 for electrical connection information.
8
TAB LOCATION
ADDING NEW DUCT
GARAGE INSTALLATION (IF ALLOWED
BY LOCAL CODES)
'U\HUV LQVWDOOHG LQ JDUDJHV PXVW EH HOHYDWHG LQFKHV
FPDERYHWKHÀRRU
9
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
BEND TAB
UP 45
o
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previousl
y
to secure
the duct in place through the tab on the appliance base.
RIGHT OR
LEFT SIDE
EXHAUST
PORTION "A"
FIXING
HOLE
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
REMOVE
SCREW
AND SAVE.
REMOVE DESIRED
KNOCKOUT (ONE ONLY).
*
Left side exhaust is
not
available for Long Vent models.
10
)L[LQJKROH
Cut the duct as shown and keep portion A.
A
ø
2
”
