GE eBike III basic Series, Руководство по обслуживанию

Страница: 95 / 124

2018111-336 Rev. B eBike III basic / comfort - 95 -
Bit
15
Bit
14
Bit
13
Bit
12
Bit
1
1
Bit
1
0
Bit
9
Bit
8
Bit
7
Bit
6
Bit
5
Bit
4
Bit
3
Bit
2
Bit
1
Bit
0
e
rror Code BIts
lIu (l
oad regulatIon and InterfaCe
pCB)
Bit Error Reaction Display / Info Troubleshooting
0 To high rotation Warning none
- advise user to cycle less than 130 rpm
1 Load out of limit Warning - advise user to cycle between
30 and 130 rpm
- perform static calibration
2 DMS Offs. invalid Safety shut down - perform static calibration OFFSET
- if error persists:
reset DMS default values
- if error persists:
replace strain gauge module
3 DMS Gain invalid Safety shut down - perform dynamic calibration
- if error persists:
replace strain gauge module
4 +24V out of range Internal error - check power supply
- check connections:
power supply to switch to LIU
cable DTU <-> LIU
5 +5V out of range Safety shut down - restart eBike (OFF / ON)
- if error persists: replace LIU
6 Brake not released. Safety shut down - check connections:
LIU <-> brake
LIU <-> strain gauge module
- perform static calibration
- if error persists:
reset DMS default values
7 Safety state mode Safety shut down - restart eBike (OFF / ON)
- if error persists:
replace LIU
8 Setup not ready Internal error - restart eBike (OFF / ON)
- if error persists:
check cable DTU <-> LIU
- check connection between
all PCB (e.g. LIU, SMU, BPU)
- replace LIU
9 CAN zykl. Timeout Safety shut down - restart eBike (OFF / ON)
- if error persists:
check cable DTU <-> LIU
- check connection between
all PCB (e.g. LIU, SMU, BPU)
- replace LRE